+44(0)1663 767888

Details

The Crown XLS2000 is a low impedance stereo power amplifier ideal for live sound with superb bass response and clear high frequencies. With bridgeable output for complete flexibiliy.

CLEARANCE LINE - ONE ONLY

Power output is highly versatile, with various modes offering from 375 watts at 8 ohms, both channels driven to a huge 2100 watts in 4 ohm, bridged mono mode.

Highly efficient, due to its switched mode power supply, this lightweight Class D slave amp is capable of meeting the requirements of any demanding audio requirement.

Internal heat sinks and forced air cooling further enhance the reliability of the Crown XLS2000 power amp.

  • XLS High Performance, Lightweight Class D amp - weighs less than 6 kg.

  • Integrated PureBand™ Crossover System for better performance and control

  • Peakx™ Limiters provide maximum output while protecting your speakers

  • XLR, 1/4", RCA inputs provide outstanding flexibility

  • Efficient forced-air fans prevent excessive thermal buildup

  • Electronically balanced XLR inputs; touchproof binding post and Speakon® outputs

  • Precision detented level controls, power switch, power LED, and six LEDs which indicate signal, clip and fault for each channel

  • Three-Year, No-Fault, Fully Transferable Warranty completely protects your investment and guarantees its specifications

Additional Information

 

Sensitivity (for full rated power at 4 ohms) 1.4 Vrms
Frequency Response (at 1 watt, 20 Hz - 20 kHz) +0dB, -1dB
Signal-to-Noise Ratio Rated as dBr to full rated 8 ohm power output (A-Weighted):
XLS1000 > 97 dB
XLS1500, XLS2000, XLS2500 > 103dB
Damping Factor (8 ohm): 10 Hz to 400 Hz > 200
Crosstalk (below rated 8Ω power) At 1 kHz: > 85dB
At 20kHz: > 55dB
Input Impedance (nominal) 20 kilohms balanced,
10 kilohms unbalanced
Load Impedance 2 to 8 ohms per channel in Stereo
4 to 8 ohms in Bridge Mono
AC Line Voltage and Frequency Configurations 
Available (± 10%)
120 VAC 60 Hz
100 VAC 50/60 Hz
220 and 240 VAC 50 Hz
Ventilation Flow-through ventilation from front to back
Cooling Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation
Air Volume Requirements (per minute per unit) 80.15 ft3 (2.27 m3)
Integrated Processing PureBandTM Crossover System
Crossover Filter: Linkwitz-Riley 24dB per Octave
Crossover Frequency Range: 50 Hz - 3 kHz
Crossover Mode: Crossover (CH1=LPF, CH2=HPF), LowPass (both channels LPF), HighPass (both channels HPF), Bridge (LPF or HPF).
PeakxTM limiters: Channels independent clip limiter designed to provide maximum output while protecting your loudspeakers
Input/Output

Input Connectors: XLR (one per channel), 1/4-Inch (one per channel), and RCA (one per channel). 1/4-Inch connectors can be used as loop-thrus to ditribute signal to additional amplifiers.

Output Connectors: Two 4-Pole Speakon® Output Connectors accept 2-pole or 4-pole Speakon® connectors. The top Speakon connector is wired for both channels so it can be used for bridgemono wiring or for stereo wiring of two wpeakers to a single Spekon connector.

One pair of back-panel binding posts per channel; accepts banana plugs or bare wire. (European models do not accept banana plugs.)

Construction XLS1000/XLS1500: 8.12-Inch (20.62cm) depth
XLS2000/XLS2500: 10.35-Inch (26.29cm) depth
Dimensions EIA Standard 19-Inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-Inch (8.9-cm) height. XLS 1000/1500: 7.7-Inch (19.6-cm) depth. XLS 2000/2500: 10.7-inch (27.2-cm) depth.
Net Weight, Shipping Weight XLS1000: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
XLS1500: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
XLS2000: 10.75 lb (4.9kg), 15.8 lb (7.1 kg)
XLS2500: 10.75 lb (4.9kg), 15.8 lb (7.1 kg)
View FileEC Declaration of Conformity: XLS1000,1500, 2000, 2500    Size: (84.61 KB)
View FileWhy An Impedance Meter is Essential for PA Installers    Size: (296.63 KB)
View FileCrown XLS Power Amps Manual    Size: (1.68 MB)
View FileCrown XLS Low Impedance Power Amp Datasheet    Size: (1.5 MB)
Product video for Crown XLS2000 Low Impedance Stereo Power Amp
we recommend
TOA ZM-104A Impedance Meter

TOA ZM-104A Impedance Meter

List price Ex. VAT: £256.49
Apart IMPMET Impedance Meter

Apart IMPMET Impedance Meter

List price Ex. VAT: £192.00
     
upsell